Sunday, September 28, 2008

more on water glue

So I know that in the last post I listed a few rubbers that would fall under the "Hurricane of the new era" category, but I tried out another one today that I would definitely add to the list: Butterfly's Tenergy. Compared to other new rubbers, the Tenergy's sponge is VERY hard and could be comparable with Hurricane; it has the same relative hardness, is quite spinny, and can deliver a pretty explosive shot. For anyone who uses Hurricane and is looking into rubbers to try out, I'd definitely suggest trying this one out before you get used to a softer sponge; the only reason I'm not flying off the walls crazy about the rubber is because I'm used to my Nimbus (Tibhar) now and I like it a lot, so I'm sort of over my "I-have-to-use-Hurricane" phase. In any case, there will never be another rubber exactly like Hurricane, so I'm over looking for a replacement.

For anyone using water glue for the first time, this is how you go about gluing: take your new sheet of rubber out of the packaging, and leave it out in open air for around 3 days. The reason you're supposed to leave it out is so the "speed effect" built in the sponge can sort of sink in and "breathe"; I'm not exactly sure how racket inspections/testing will work, but I've been told that unless your sponge gets the 72 hours of open air it needs, it could fail the test. Anyway, after 3 days, put a glob of glue roughly the size of a quarter, maybe a little smaller, in the middle of the sponge, and spread it out as evenly as possible; any bumps will be immediately noticable when you put the rubber on the blade. Water glue looks basically just like Elmer's glue (the white pastey stuff we used in like first grade for arts and crafts), and is just as harmless- the gluing process can get VERY messy, so make sure you have a tissue handy, but in case it gets on your hands or something, it's not toxic.. no biggie. To glue the blade, use a very small glob of glue and spread it evenly. When wet, the glue looks white, but will look transparent when dry, so you'll definitely be able to tell when it's dry. It should take only about 5-10 minutes for everything to dry. One layer of glue for both wood and rubber is definitely enough, and it wouldn't make a bit of difference if you use more glue anyway, so the whole gluing process should take no more than 10-15 minutes, if even that much. Plus, gluing can be a one-time experience for each rubber; you do it once and never again (unless you need to because it's coming off or something like that).

Overall, I'm pretty chill with the new glues/rubbers. My only issue is that my forehand rubber (Tibhar's Nimbus) has sort of a short lifespan; while I only need to glue it once, it usually doesn't last me more than 2 or 3 months. But, it's nice not to have to worry about gluing before practice anymore, and I'm down for not inhaling poisonous toxins any day.

3 comments:

Anonymous said...

Sweet post!

Anonymous said...

Another german TT site:

Eine interessante Seite zum Thema Tischtennis.

Auf was sollte man beispielsweise bei einem Tischtennisshop

oder bei einer Tischtennisplatte achten? Mit
Special zum Thema: Tischtennisplatte
wetterfest

Anonymous said...

You might like to mention which water glue yuo're referring to here, as there are many new ones on the market, and some are very different to this.